• Fix Hinge on LG Exalt

  • MMyiLevel 3 - Gold Member

    william If you read up thread, Or rather if you did not read up thread, be really careful if you're using heat because you'll mess up the screen.

    Use a metrocard, that's something that you have in New York, Or a wedge bar any plastic piece to pull it up. Even a playing card should help.
    If you ever fixed any phone or have any plastic prybars that's the best tool.
    Just curious what are you looking to do?

    I would not advise you to use any metal knives or sharp objects you'll end up scratching the plastic screen and the real screen.

      Myi thx
      I'm trying to replace the hinge

      Myi I'm trying with playing card but it just bends and doesn't pry up the screen??

      • Myi replied to this.
        • MMyiLevel 3 - Gold Member

          william also be careful not to snap the little tabs when pulling off the cover. They break really easy.
          Where the blue tip is pointing to.

          [Login to see the link]

            6 days later
            • FlippyLevel 6 - Platinum Elite Member

              Can someone post a link for a replacement part? I am looking for the LG exalt Speaker/outer mic.

              • FlippyLevel 6 - Platinum Elite Member

                william Yes, I know about that. My question is which part is the Mic? I see this:
                [Login to see the link]
                But I dont know if its for the regular mic, speaker mic, or either. Want to know if anyone has any experience with this.

                • Myi replied to this.
                  7 days later
                  • MMyiLevel 3 - Gold Member

                    Flippy So if you need the speaker that would be...
                    [Login to see the link]

                    And if you'll need a new mic because people can't hear you on speaker or the mic on the main pcb board, meaning when your off speaker people cant hear you then you'll need ...
                    [Login to see the link]

                    Yes there's two mics. one for speaker and one when off speaker. they are both the same. Though they need to be soldered on or using heat to pull off the old ones and put the new one on. or spend $20 and but a new board on which has a new mic, so in essence another $17-$18. though its backordered Now.

                      • MMyiLevel 3 - Gold Member

                        william Youre welcome. how did the repair go?

                        • FlippyLevel 6 - Platinum Elite Member

                          Myi Great thank you! The mic for being on speaker is the little hole on the front of the unit, correct?

                          • Myi replied to this.

                            [Login to see the link] actually not that good whats the proper way to heat the sides without burning the lcd screen? i had to buy new glue for it bc heating didnt work for me??

                            • Myi replied to this.
                              • MMyiLevel 3 - Gold Member

                                william Don't use any glue. Just a pry bar.

                                • MMyiLevel 3 - Gold Member

                                  william yes use Double sided sticky tape. That way you can remove the screen again should you. Vs glue which will leave behind a mess.

                                  The only reason I suggested to use very little heat was so you can remove the lens and put back after the repair, while being able to use adhesive again. At this point like mentioned use double sided sticky tape like you see from gpd.
                                  Gn

                                  Myi how do you remove it with out snapping them?

                                  • Myi replied to this.

                                    [Login to see the link] how to remove the top part of phone from bottom by the hinge with out cracking anything??

                                    • Myi replied to this.