MMyiLevel 3 - Gold Member
- Edited
william [Login to see the link]
Try using such a plastic prybar.
william [Login to see the link]
Try using such a plastic prybar.
This type of thing
[Login to see the link]
[Login to see the link]
Can someone post a link for a replacement part? I am looking for the LG exalt Speaker/outer mic.
william Yes, I know about that. My question is which part is the Mic? I see this:
[Login to see the link]
But I dont know if its for the regular mic, speaker mic, or either. Want to know if anyone has any experience with this.
Flippy So if you need the speaker that would be...
[Login to see the link]
And if you'll need a new mic because people can't hear you on speaker or the mic on the main pcb board, meaning when your off speaker people cant hear you then you'll need ...
[Login to see the link]
Yes there's two mics. one for speaker and one when off speaker. they are both the same. Though they need to be soldered on or using heat to pull off the old ones and put the new one on. or spend $20 and but a new board on which has a new mic, so in essence another $17-$18. though its backordered Now.
[Login to see the link] actually not that good whats the proper way to heat the sides without burning the lcd screen? i had to buy new glue for it bc heating didnt work for me??
[Login to see the link] i meant lens adhesive to stick the lens back to the phone
william yes use Double sided sticky tape. That way you can remove the screen again should you. Vs glue which will leave behind a mess.
The only reason I suggested to use very little heat was so you can remove the lens and put back after the repair, while being able to use adhesive again. At this point like mentioned use double sided sticky tape like you see from gpd.
Gn
[Login to see the link] how to remove the top part of phone from bottom by the hinge with out cracking anything??
william Good Q. Quite hard. No tip or trick on my end. Just try your best.
If you do end up snapping it, it will cause the cover to pop off, which will then cause the hinge to come loose, which can allow for the top and bottom to separate and eventually and snapping the ribbon cable.
Yes I have many spare parts of those little black frames connected to the front screen, which can easily be swapped out when I snap one upon removing the cover.
william Message me and I can guide. You, much easier than posting here back and forth.
[Login to see the link]
Myi I have a guy in lakewood for $65 or that price range.
Feel free to email me at [[Login to see the link]](mailto:[Login to see the link])
or here's a phone number to text him. (347) 201-2501.