• Fix Hinge on LG Exalt

  • MMyiLevel 3 - Gold Member

    Flippy So if you need the speaker that would be...
    [Login to see the link]

    And if you'll need a new mic because people can't hear you on speaker or the mic on the main pcb board, meaning when your off speaker people cant hear you then you'll need ...
    [Login to see the link]

    Yes there's two mics. one for speaker and one when off speaker. they are both the same. Though they need to be soldered on or using heat to pull off the old ones and put the new one on. or spend $20 and but a new board on which has a new mic, so in essence another $17-$18. though its backordered Now.

      • MMyiLevel 3 - Gold Member

        william Youre welcome. how did the repair go?

        • FlippyLevel 6 - Platinum Elite Member

          Myi Great thank you! The mic for being on speaker is the little hole on the front of the unit, correct?

          • Myi replied to this.

            [Login to see the link] actually not that good whats the proper way to heat the sides without burning the lcd screen? i had to buy new glue for it bc heating didnt work for me??

            • Myi replied to this.
              • MMyiLevel 3 - Gold Member

                william Don't use any glue. Just a pry bar.

                • MMyiLevel 3 - Gold Member

                  william yes use Double sided sticky tape. That way you can remove the screen again should you. Vs glue which will leave behind a mess.

                  The only reason I suggested to use very little heat was so you can remove the lens and put back after the repair, while being able to use adhesive again. At this point like mentioned use double sided sticky tape like you see from gpd.
                  Gn

                  Myi how do you remove it with out snapping them?

                  • Myi replied to this.

                    [Login to see the link] how to remove the top part of phone from bottom by the hinge with out cracking anything??

                    • Myi replied to this.
                      • MMyiLevel 3 - Gold Member

                        william Good Q. Quite hard. No tip or trick on my end. Just try your best.
                        If you do end up snapping it, it will cause the cover to pop off, which will then cause the hinge to come loose, which can allow for the top and bottom to separate and eventually and snapping the ribbon cable.
                        Yes I have many spare parts of those little black frames connected to the front screen, which can easily be swapped out when I snap one upon removing the cover.

                        14 days later

                        does anyone know where i can get the sticky glue to stick the screen back in place after taking off to replace hinge??

                        not the actuaally screen the lens on the outside

                          • FlippyLevel 6 - Platinum Elite Member

                            william Try a tiny bit of gorilla glue. Even crazy glue should work fine.

                            i would buy the material the phone comes with just in case i would need to open it up again but i just dont know where to buy it?

                              on the side of the flex ribbon on the keypad frame the hinge cracked off the phone and I lost the metal piece that was in it (not the lock on the other side) and the little plastic cover on the outside of the frame do any1 know what those pieces are called how I could get them?

                              • Myi replied to this.