WwilliamLevel 1 - Junior Member
[Login to see the link] i meant lens adhesive to stick the lens back to the phone
[Login to see the link] i meant lens adhesive to stick the lens back to the phone
william yes use Double sided sticky tape. That way you can remove the screen again should you. Vs glue which will leave behind a mess.
The only reason I suggested to use very little heat was so you can remove the lens and put back after the repair, while being able to use adhesive again. At this point like mentioned use double sided sticky tape like you see from gpd.
Gn
[Login to see the link] how to remove the top part of phone from bottom by the hinge with out cracking anything??
william Good Q. Quite hard. No tip or trick on my end. Just try your best.
If you do end up snapping it, it will cause the cover to pop off, which will then cause the hinge to come loose, which can allow for the top and bottom to separate and eventually and snapping the ribbon cable.
Yes I have many spare parts of those little black frames connected to the front screen, which can easily be swapped out when I snap one upon removing the cover.
william Message me and I can guide. You, much easier than posting here back and forth.
[Login to see the link]
Myi I have a guy in lakewood for $65 or that price range.
Feel free to email me at [[Login to see the link]](mailto:[Login to see the link])
or here's a phone number to text him. (347) 201-2501.
does anyone know where i can get the sticky glue to stick the screen back in place after taking off to replace hinge??
not the actuaally screen the lens on the outside
i would buy the material the phone comes with just in case i would need to open it up again but i just dont know where to buy it?
william Read this post from [Login to see the link]
TL;DR
Probably best off with [Login to see the link]
on the side of the flex ribbon on the keypad frame the hinge cracked off the phone and I lost the metal piece that was in it (not the lock on the other side) and the little plastic cover on the outside of the frame do any1 know what those pieces are called how I could get them?
princeofthecS you basically need a new hinge.
That's what I would call it.
I successfully replaced the top frame, but the hinge is very loose, with no resistance. It just flops closed. Is there some kind of piece that secures the hinge, that may have fallen out or is out of place? Thanks in advance.
I was also wondering about this. How do you fit both sides snugly together? On one side there's that little metal protrusion as pictured above, but on the other side there's a little metal rod that I can't seem to figure out how it goes.